Zircon LaserVision Auto Instructions - Plumb And Layout Setup

In vertical mode, the LaserVision® AUTO projects a rotatable beam of laser light that can be used as a spot, rotated, or scanned. Simultaneously, a fixed beam is projected at 90° to the rotatable beam from the top of the rotating head. The 90° beam provides a convenient way to define right angle intersections for interior layout. See vertical and line layout setups for complete instruction on aligning the vertical plane of light.

When the LaserVision® AUTO is in vertical mode, it is completely manual in operation and will not turn off if it is disturbed. Check the vertical vial and your benchmarks regularly to be sure your work will be accurate. The LaserVision® AUTO is designed for vertical alignment up to two stories high.

Diagram 2 The base of the LaserVision® AUTO has four notches molded-in to quickly allow the transferring of points from floor to ceiling. By simply drawing an intersection with two lines, the base notches act as guides to align the LaserVision® AUTO over the intersection. Once over the point, center the bubble in the circular vial and the self leveling system will operate, projecting a self plumbed spot on the ceiling.


	TABLE OF CONTENTS

LaserVision® AUTO Instructions - Plumb And Layout Setup