LaserVision® AUTO Instructions - Vertical & Line Layout Setup

Establish two points of alignment for the plane of light, assemble the vertical mount and attach the laser to it. Set the laser over your near point and use the Y-axis leveling screw (now at the bottom of the laser) to rough center the vertical vial (visible through the window in the control panel now at the top of the laser). Note that the surface the vertical mount is resting on should be reasonably level. Turn the laser on and stop the beam rotation (using the "-" button). Manually turn the rotating head to project the beam downward toward your near point while you rough align the laser/mount assembly by sliding the entire assembly. Turn-on the rotation (using the "+" button). Keep the beam crossing the near point while sliding the base of the assembly until the rotating beam is on or near your far point.

The X-axis leveling knob (now nearest the top of the laser) provides a fine mechanical line control to accurately align the beam plane to your far point. Visually check your far point to be sure the beam is crossing it and verify that the beam is still crossing your near point. Make a final adjustment of the vertical vial after the alignment is done. Draw a line around the feet of the mount so that you can verify that the mount has not been moved. Also check that the beam is still crossing your points from time to time. The vertical mount can also be attached to a tripod and vertical setups can be made outdoors with an optional receiver.

Check the vertical vial and your benchmarks regularly to be sure your work will be accurate. The LaserVision® AUTO is designed for vertical alignment up to two stories high.