MultiScanner® i320 OneStep®
MultiScanner® i320 OneStep® quickly and easily locates the edges and center of wood and metal studs and joists behind walls, floors, and ceilings. It also locates metal targets up to 3 inches (76 mm) deep. A 3-mode switch makes it easy to change functions, while the display screen, SpotLite® Pointing System, and audio tone all indicate the location of the target. The signal strength indicator helps to distinguish between shallow and deep targets.
- Stud Scan mode locates the edges and center of wood or metal studs up to 3/4 inch (19 mm) deep
- DeepScan® mode doubles the scanning depth to 1 1/2 inches (38 mm)
- Metal mode detects non-ferrous metal, such as copper pipes, up to 1 1/2 inches (38 mm) deep, and ferrous metal, such as rebar, up to 3 inches (76 mm) deep
- WireWarning® detection indicates the presence of live, unshielded electrical wire up to 2 inches (51 mm) deep in stud and metal scanning modes
- ACT™ (Auto Correcting Technology) automatically corrects common user errors, such as when scanning begins over a stud
|
|
|
Find Stud Center
CenterVision® technology is the most exciting innovation to hit stud finding since Zircon introduced the original electronic stud finder back in 1980.
Instead of the dual-scan-and-mark procedure, users need only make one pass to find dead-center every time.
CenterVision® tools will even find the center of a double stud, although it will display a wide "center" zone.
CenterVision® technology takes all the guesswork out of locating the best place to anchor into a stud.
Scan Thick Walls for Studs
Sometimes because of extra layers of wallboard or paneling, the studs are too deep to be found by standard scanning.
Tools with Zircon's Deepscan® feature can be switched to a higher strength to detect studs and joists up to 1 1/2 inches deep.
This extra power shouldn't be used unless necessary, because on normal walls it is oversensitive and results in too many false positives.
WireWarning® Detection
Tools with the WireWarning® detection feature continuously detect hot electrical wires (unshielded) up to 2 inches deep while you are scanning for studs or metal. The WireWarning® detection is always on, in all modes, to alert you to the presence of hot, unshielded AC wires behind the wall.
|
|
|
| |
